During text detection, KeyView analyses the first 1 kB and last 1 kB of data in a document. If less than 10% of that data consists of non-ASCII characters, KeyView detects the document as a text file.
However, depending on the type of documents you are working with, the default settings might not provide the desired level of accuracy. Configuration flags enable you to change the amount of data to read at the end of a file, the percentage of non-ASCII characters permitted in a text file, and whether to use or ignore the file extension to determine the document format.
During file detection, KeyView reads characters from the beginning and end of a file—by default, it reads the first and last 1,024 bytes of data. Large text files might contain many irrelevant characters at the end of a file, so KeyView might not accurately detect the file format. You can set a configuration flag to increase the amount of data to read from the end of a file during detection.
To change the amount of data to read during detection
In the formats.ini file, set the following flag in the detection_flags section:
[detection_flags] non_ascii_chars_end_block_size=kB
where kB is the number of kilobytes to read from the end of the file, from 0 to 10. The default value is 1.
The file size must be greater than the value specified in the flag. If the flag value is greater than the file size, KeyView does not use the flag.
By default, if less than 10% of the analyzed data in a document consists of non-ASCII characters, it is detected as a text file. Depending on the type of files that you are working with, changing the default percentage might increase detection accuracy.
To change the percentage of non-ASCII characters allowed in text files
In the formats.ini file, set the following flag in the detection_flags section:
[detection_flags]
non_ascii_chars_in_text=N
where N is the percentage of non-ASCII characters to allow in text files. Files that contain a lower percentage of non-ASCII characters than N are detected as text files. The default value is 10.
By default, if a document contains consecutive NULL bytes, it is not detected as text. Depending on the type of files that you are working with, changing the default might increase detection accuracy.
To allow consecutive NULL bytes of ASCII characters in text files
In the formats.ini file, set the following flag in the detection_flags section:
[detection_flags]
ascii_allow_null_bytes=1
The default value is 0 (do not allow consecutive NULL bytes).
Sometimes KeyView detects certain file formats, such as CSV, as ASCII because of the content of the documents. In such cases, you can configure KeyView to use the file extension to determine the document format. Using the file extension can improve detection of formats such as CSV, but might not detect text files successfully if they have incorrect file extensions.
To use the file extension for ASCII files during detection
In the formats.ini file, set the following flag in the detection_flags section:
[detection_flags] use_extension_for_ascii=1
The default is 0 (do not use the file extension).
|
|