Open topic with navigation
To reduce the frequency of I/O operations, and consequently improve performance, the KeyView readers load file data into memory. The readers then read the data from the cache rather than the physical disk. You can configure the amount of memory used for file caching through the
formats.ini file. Generally, when you increase the memory, performance improves.
By default, KeyView uses a maximum of 1 MB of memory for each thread—assuming a thread contains only one instance of
pContext that is returned from the session initialization (see fpInit()). If the file data is larger than 1 MB, up to 1 MB of data is cached and the data beyond 1 MB is read from disk. The minimum amount of memory that can be used for file caching is 64 KB.
To determine a reasonable value, divide the maximum amount of memory you want KeyView to use for file caching by the total number of threads. For example, if you want KeyView to use a maximum of 50 MB of memory and have 10 threads, set the value to 5 MB.
To modify the memory allocated for file caching, change the value for the following parameter in the
[DiskCache] section of the
The value is in kilobytes. If this parameter is not set or is set to 0 (zero), the minimum value of 64 KB is used.