Getting Started > Configure Digital Safe Connector > Start and Stop the Connector > Stop a Connector

Stop a Connector
Stop a connector from running by using one of the following methods.
To stop the connector using Windows Services
1.
2.
Select the ConnectorInstallName service, and click Stop.
3.
To stop the connector service by sending a command to the service port
Type the following command in the address bar of your browser:
http://host:ServicePort/action=stop
where,
 
The IP address (or name) of the machine on which the Digital Safe Connector is running.
The Digital Safe Connector service port (specified in the [Service] section of the Digital Safe Connector configuration file).